[quile]

Hey guys. I got a Razor Drifter for my younger kids for Christmas and I am looking to upgrade the batteries to 3 12v 15AH (36v) batteries my older son at 140lbs can get in on the action.

I want to be able to install a second speed regulator that would allow me to reduce the overall speed for my younger boys, but then crank it up for my older son.

Would something like this between the controller and the motor work? I assume it has to be at least 30A.

http://www.ebay.com/itm/Motor-Speed-Con ... ce&vxp=mtr



I am also looking into is 5" schedule 80 PVC and 5" rubber couplers to slide over the drifter wheels. One for a cheaper alternative to replacing the stockers and one for "slicks".

Thanks.

[aidanworthington]

sorry that would't work
(both ideas)

the easyist way to restrict the throttle would be a varible resistor on the throttle signal wire
(10k)
and when you know the requied resistance swap it out for a resistor and key swich
(using a 30amp controler)
ie

[quile]

Thanks for the feedback. I wish I understood why my idea would not work.

Is it possible just to use a variable resistor and leave it in, instead of using a key switch?

Also, the 10K variable resistor has 3 terminals, which two do I use?

http://www.amazon.com/potentiometer-pot ... 8DECE97940

[aidanworthington]

yes you can
(just a key swich gives you the control not the kids)

middle and one end

[bassiclyLouDog]

This is way cool. If I was more handy a few years ago I'd have done this for the kids in the neighborhood lol