Moderators: robnewyork, bassiclyLouDog, gameboy

By SpaceKaseJase
#32003
Just wanted to ensure my lipos are fine. I've got two 16000 6s lipo packs (Multistar) for a project I just recently finished. I purchased them back in October, and had them sitting for a couple months in storage mode. I use two lipo buzzers from Hobbyking to check for low voltage. I also use a genuine icharger 206b to balance charge them. Every time I connect the buzzers to either battery, they always read the 5th cell around 1.0 v lower than the rest. However, my iCharger reads each cell as balanced with as much difference between any cell as 0.1v. Should this be concerning, or is it just my cheap lipo buzzers that may be out of whack? I honestly think it's the latter. Anyone else experience this?


Razor e200 Modifications

Not sure how well those stock 24v motors will hold[…]

This building was existing. The Nissan Z Coupe is […]